RANCANGAN SISTEM VAKUM UNTUK PROSES PENGERASAN KOMPOSIT DENGAN METODE WET LAY UP DI PROGRAM STUDI TEKNIK PESAWAT UDARA

  • Riyan Maulana Yusuf
  • Ego Widoro
  • Djoko Herwanto
Keywords: composite panel, composite curing, vacuum system

Abstract

Composite Curing process is need vacuum system to remove air bubble and heating system to decrease time of curing proses. Vacuum and heating system at composite panel curing practical at program studi teknik pesawat udara conducted separately, so need composite panel curing equipment that have integrated Vacuum and heating system. Vacuum system in this composite panel curing equipment is designed by design step including vacuum pump selection, hose selection, vacuum system design. Discussion results rate of flow of 37 L/min. With the fluid velocity of 20m/s. vacuum pump pressure of 14.5 inHg. Components required for vacuum system is a vacuum pump, vacuum regulator, vacuum gauge, nipple, vacuum bagging port, flexible Teflon hose.

Downloads

Download data is not yet available.

References

Data tidak tampil
Published
2019-06-10
How to Cite
1.
Riyan Maulana Yusuf, Ego Widoro, Djoko Herwanto. RANCANGAN SISTEM VAKUM UNTUK PROSES PENGERASAN KOMPOSIT DENGAN METODE WET LAY UP DI PROGRAM STUDI TEKNIK PESAWAT UDARA. JIA [Internet]. 2019Jun.10 [cited 2024Apr.27];12(2):19-8. Available from: https://journal.ppicurug.ac.id/index.php/jurnal-ilmiah-aviasi/article/view/157
Issue
Vol. 12 No. 2 (2019): Langit Biru: Jurnal Ilmiah Aviasi
Section
Articles

Copyright (c) 2019 Riyan Maulana Yusuf, Ego Widoro, Djoko Herwanto

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

 

 

Most read articles by the same author(s)

1 2 > >>